Network Test Network Validators (PoE)

Network Validators (PoE)

LinkIQ Cable + Network Tester

Cable testing you trust. Network testing you need.

Measure network capacity up to 10 Gig via frequency based measurements
Troubleshoot active networks by providing connected switch information (Switch Name, Port Number, and VLAN info)
Install and troubleshoot PoE devices via Switch Negotiation and PoE Load test
Graphical wiremap and length test to identify common faults that occur with cabling installation
Document work through LinkWare™ PC reporting
Supports Industrial Ethernet (EtherNet/IP, PROFINET, EtherCAT, and others)
Industrial Ethernet Kit supports Industrial Connectors (M8D, M12D, M12X)

MicroScanner Cable Verifier Series

The technician’s tool for installing and troubleshooting Ethernet devices.

Quickly determine if a problem is caused by a bad or unconnected cable, insufficient power, or a Powered Device (PD).
Ethernet Alliance Certified to IEEE-802.3™ standards for reliable multivendor interoperability
Information for the Network Engineer to investigate potential switch configuration or malfunctions.
PoE Switch Verification – Determine if a switch port can provide enough power by reporting PoE class (0-8)

Powered Pairs – Graphically identifies powered pairs. Including Dual Signature where the switch port delivers power on 2 or 4 pairs (802.3bt or PoE ++)

Active Switch Detection - Determine if a cable is connected to a switch port and port speed up to 10G

Cable Testing – Identify any shorted, open or crossed wires at both ends, length of each pair, and send tones to find cables.

Validate and troubleshoot your Industrial Ethernet copper cabling

PoE Injector verification - Display injector voltage level